V-94269

Discussion

Application protocol anomaly detection examines application layer protocols such as HTTP to identify attacks based on observed deviations in the normal RFC behavior of a protocol or service. This type of monitoring allows for the detection of known and unknown exploits that exploit weaknesses of commonly used protocols. Since protocol anomaly analysis examines the application payload for patterns or anomalies, an HTTP proxy must be included in the ALG. This ALG will be configured to inspect inbound and outbound HTTP communications traffic to detect protocol anomalies such as malformed message and command insertion attacks.

Check Content

Check 1 (This is an uncommon configuration. If it is found, it has been deliberately done by the Proxy administrator and cannot/should not be removed without consultation with/advice from the administrator.)
1. Browse to Configuration >> Policy >> Policy Files and click the button to view the installed policy. 
2. Using "<Ctrl>-F", perform a search for the exact terms "detect_protocol(no)". 

If this phrase appears in the policy file, this is a finding.

Discuss with the ProxySG administrator to determine why this was configured and whether an exception must be approved.

Check 2
1. Browse to Configuration >> Services >> Proxy Services, select each HTTP proxy service to be reviewed, and click "Edit Service". 
2. Verify that the "Detect Protocol" checkbox is selected.

If Symantec ProxySG providing intermediary services for HTTP does not inspect inbound HTTP traffic for protocol compliance and protocol anomalies, this is a finding.