STIGhubSTIGhub
STIGsSearchCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 3 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Honeywell Android 9.x COBO Security Technical Implementation Guide

V-235043

CAT III (Low)

The Honeywell Mobility Edge Android Pie device must be configured to disable Bluetooth or configured via User Based Enforcement (UBE) to allow Bluetooth for only HSP (Headset Profile), HFP (HandsFree Profile), or SPP (Serial Port Profile) capable devices.

Rule ID

SV-235043r852703_rule

STIG

Honeywell Android 9.x COBO Security Technical Implementation Guide

Version

V1R2

CCIs

CCI-000366, CCI-001761

Discussion

Some Bluetooth profiles provide the capability for remote transfer of sensitive DoD data without encryption or otherwise do not meet DoD IT security policies and therefore should be disabled. SFR ID: FMT_SMF_EXT.1.1 #18h

Check Content

Determine if the AO has approved the use of Bluetooth at the site.

If the AO has not approved the use of Bluetooth, verify Bluetooth has been disabled.

On the MDM console:
1. Open Restrictions section.
2. Ensure "Disallow Bluetooth" is set.

On the Honeywell Android Pie device:
1. Go to Settings >> Connected Devices >> Connection Preferences >> Bluetooth.
2. Ensure that it is set to "Off" and cannot be toggled to "On".

If the AO has approved the use of Bluetooth, on the Honeywell Android Pie device:
1. Go to Settings >> Connected Devices.
2. Verify only approved Bluetooth connected devices using approved profiles are listed.

If the AO has not approved the use of Bluetooth, and Bluetooth use is not disabled via an MDM managed device policy, this is a finding.

If the AO has approved the use of Bluetooth, and Bluetooth devices using unauthorized Bluetooth profiles are listed on the device under "Connected devices", this is a finding.

Fix Text

Configure the Honeywell Android device to disable Bluetooth or if the AO has approved the use of Bluetooth (for example, for car handsfree use), train the user to connect to only authorized Bluetooth devices using only HSP, HFP, or SPP Bluetooth capable devices (User Based Enforcement [UBE]).

To disable Bluetooth use the following procedure:

On the MDM console: 
1. Open Restrictions section.
2. Toggle "Disallow Bluetooth" to "On".

The user training requirement is satisfied in requirement HONW-09-008700.