STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 4 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Cisco IOS XR Router RTR Security Technical Implementation Guide

V-216770

CAT II (Medium)

The Cisco out-of-band management (OOBM) gateway router must be configured to have separate IGP instances for the managed network and management network.

Rule ID

SV-216770r1117237_rule

STIG

Cisco IOS XR Router RTR Security Technical Implementation Guide

Version

V3R3

CCIs

CCI-001414

Discussion

If the gateway router is not a dedicated device for the OOBM network, implementation of several safeguards for containment of management and production traffic boundaries must occur. Since the managed and management network are separate routing domains, configuration of separate Interior Gateway Protocol routing instances is critical on the router to segregate traffic from each network.

Check Content

This requirement is not applicable for the DODIN Backbone.

Verify that the OOBM interface is an adjacency in the IGP domain for the management network via separate VRF as shown in the example below.

router ospf 2
 vrf MGMT
  area 0
   interface GigabitEthernet0/0/0/0.2
   !
  !
 !
!
router ospf 3
 vrf PROD
  area 0
   interface GigabitEthernet0/0/0/0.3
   !
  !
 !
!

If the router is not configured to have separate IGP instances for the managed network and management network, this is a finding.

Fix Text

This requirement is not applicable for the DODIN Backbone.

Configure the router to have a separate IGP instance for the management network as shown in the example below.

RP/0/0/CPU0:R2(config)#router ospf 2 vrf MGMT
RP/0/0/CPU0:R2(config-ospf-vrf)#area 0
RP/0/0/CPU0:R2(config-ospf-vrf-ar)#interface GigabitEthernet0/0/0/0.2
RP/0/0/CPU0:R2(config-ospf-vrf-ar-if)#exit
RP/0/0/CPU0:R2(config-ospf-vrf-ar)#exit
RP/0/0/CPU0:R2(config-ospf-vrf)#exit
RP/0/0/CPU0:R2(config-ospf)#exit
RP/0/0/CPU0:R2(config)#router ospf 3 vrf PROD
RP/0/0/CPU0:R2(config-ospf-vrf)#area 0
RP/0/0/CPU0:R2(config-ospf-vrf-ar)#interface GigabitEthernet0/0/0/0.3
RP/0/0/CPU0:R2(config-ospf-vrf-ar-if)#end