STIGhubSTIGhub
STIGsSearchCompareAbout

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • Compare Versions

Resources

  • About
  • VPAT
  • DISA STIG Library
STIGs updated 2 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Cisco IOS Switch L2S Security Technical Implementation Guide

V-220625

CAT II (Medium)

The Cisco switch must manage excess bandwidth to limit the effects of packet-flooding types of denial-of-service (DoS) attacks.

Rule ID

SV-220625r991847_rule

STIG

Cisco IOS Switch L2S Security Technical Implementation Guide

Version

V3R1

CCIs

CCI-001095, CCI-004866

Discussion

Denial of service is a condition when a resource is not available for legitimate users. Packet-flooding distributed DoS (DDoS) attacks are referred to as volumetric attacks and have the objective of overloading a network or circuit to deny or seriously degrade performance, which denies access to the services that normally traverse the network or circuit. Volumetric attacks have become relatively easy to launch by using readily available tools such as Low Orbit Ion Cannon or botnets. Measures to mitigate the effects of a successful volumetric attack must be taken to ensure that sufficient capacity is available for mission-critical traffic. Managing capacity may include, for example, establishing selected network usage priorities or quotas and enforcing them using rate limiting, Quality of Service (QoS), or other resource reservation control methods. These measures may also mitigate the effects of sudden decreases in network capacity that are the result of accidental or intentional physical damage to telecommunications facilities (such as cable cuts or weather-related outages).

Check Content

Review the switch configuration to verify QoS has been enabled as shown below:

mls qos

If QoS has not been enabled, this is a finding.

Fix Text

Enable QoS on the switch:

SW1(config)#mls qos