STIGhubSTIGhub
STIGsSearchCompareAbout

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • Compare Versions

Resources

  • About
  • VPAT
  • DISA STIG Library
STIGs updated 2 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Cisco IOS XE Switch L2S Security Technical Implementation Guide

V-220661

CAT II (Medium)

The Cisco switch must have Dynamic Address Resolution Protocol (ARP) Inspection (DAI) enabled on all user VLANs.

Rule ID

SV-220661r929003_rule

STIG

Cisco IOS XE Switch L2S Security Technical Implementation Guide

Version

V3R2

CCIs

CCI-002385

Discussion

DAI intercepts Address Resolution Protocol (ARP) requests and verifies that each of these packets has a valid IP-to-MAC address binding before updating the local ARP cache and before forwarding the packet to the appropriate destination. Invalid ARP packets are dropped and logged. DAI determines the validity of an ARP packet based on valid IP-to-MAC address bindings stored in the DHCP snooping binding database. If the ARP packet is received on a trusted interface, the switch forwards the packet without any checks. On untrusted interfaces, the switch forwards the packet only if it is valid.

Check Content

Review the switch configuration to verify that Dynamic Address Resolution Protocol (ARP) Inspection (DAI) feature is enabled on all user VLANs. 

hostname SW2
…
…
…
ip arp inspection vlan 2,4-8,11

Note: DAI depends on the entries in the DHCP snooping binding database to verify IP-to-MAC address bindings in incoming ARP requests and ARP responses.

If DAI is not enabled on all user VLANs, this is a finding.

Fix Text

Configure the switch to have Dynamic Address Resolution Protocol (ARP) Inspection (DAI) enabled on all user VLANs as shown in the example below:

SW2(config)#ip arp inspection vlan 2,4-8,11