Rule ID
SV-80941r1_rule
Version
V1R3
CCIs
To prevent non-secure protocol communications with the organization's local SNMPv3 services, the SNMP client on the Juniper SRX must be configured for proper identification and strong cryptographically-based protocol for authentication. SNMPv3 defines a user-based security model (USM), and a view-based access control model (VACM). SNMPv3 USM provides data integrity, data origin authentication, message replay protection, and protection against disclosure of the message payload. SNMPv3 VACM provides access control to determine whether a specific type of access (read or write) to the management information is allowed. The Junos operating system allows the use of SNMPv3 to monitor or query the device for management purposes. Junos does not allow SNMPv3, of any type, to be used to make configuration changes to the device. SNMPv3 is disabled by default and must be enabled for use. SNMPv3 is the DoD-preferred method for monitoring the device securely. If SNMPv3 is not being used, it must be disabled. The following commands will configure SNMPv3. The Junos operating system allows the use of FIPS approved protocols for both authentication (SHA1) and for privacy (AES128). These protocols should be used to ensure secure management connections.
Verify SNMPv3 is enabled and configured. [edit] show snmp If an SNMP stanza does not exist, this is not a finding. If SNMPv3 is not configured to meet DoD requirements, this is a finding. If versions earlier than SNMPv3 are enabled, this is a finding.
Enable and configure SNMPv3 and configure a trap and community string. [edit] set snmp location <LOCATION-NAME> set snmp v3 usm local-engine user <USER-NAME> privacy-AES128 set snmp v3 vacm security-to-group security-model usm security-name <SECURITY-NAME> group <GROUP-NAME> set snmp v3 vacm access group <GROUP-NAME> default-context-prefix security-model usm security-level privacy read-view all set snmp v3 vacm access group <GROUP-NAME> default-context-prefix security-model usm security-level privacy notify-view all set snmp v3 target-address <target-address-name> tag-list <SNMP-trap-receiver> set snmp v3 target-address <TARGER-ADDRESS-NAME> target-parameters <PARMS-NAME> set snmp v3 target-parameters <PARMS-NAME> parameters message-processing-model v3 set snmp v3 target-parameters <PARMS-NAME> parameters security-model usm set snmp v3 target-parameters <PARMS-NAME> parameters security-level privacy set snmp v3 target-parameters <PARMS-NAME> parameters security-name <SECURITY-NAME> set snmp v3 target-parameters <PARMS-NAME> notify-filter device-traps set snmp v3 notify <SNMP-TRAPS> type trap set snmp v3 notify <SNMP-TRAPS> tag <SNMP-TRAP-RECEIVER> set snmp v3 notify-filter device-traps oid jnxChassisTraps include set snmp v3 notify-filter device-traps oid jnxChassisOKTraps include set snmp v3 notify-filter device-traps oid system include set snmp v3 notify-filter device-traps oid .1 include set snmp v3 notify-filter device-traps oid snmpMIBObjects include set snmp engine-id use-mac-address set snmp view all oid .1 include set snmp view all oid system include set snmp view all oid jnxBoxAnatomy include set snmp view all oid snmpMIBObjects include