STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 1 hour ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Router Security Requirements Guide

V-207101

CAT II (Medium)

The BGP router must be configured to reject outbound route advertisements for any prefixes that do not belong to any customers or the local autonomous system (AS).

Rule ID

SV-207101r1137897_rule

STIG

Router Security Requirements Guide

Version

V5R2

CCIs

CCI-001368

Discussion

Advertisement of routes by an autonomous system for networks that do not belong to any of its customers pulls traffic away from the authorized network. This causes a denial of service (DoS) on the network that allocated the block of addresses and may cause a DoS on the network that is inadvertently advertising it as the originator. It is also possible that a misconfigured or compromised router within the GIG IP core could redistribute IGP routes into BGP, thereby leaking internal routes. This requirement also applies to Zero Trust initiatives.

Check Content

This requirement is not applicable for the DODIN Backbone. 

Review the router configuration to verify that there is a filter defined to only advertise routes for prefixes that belong to any customers or the local AS.

The prefix filter must be referenced outbound on the appropriate BGP neighbor statements.

If the router is not configured to reject outbound route advertisements that belong to any customers or the local AS, this is a finding.

Fix Text

Configure all eBGP routers to filter outbound route advertisements for prefixes that are not allocated to or belong to any customer or the local AS.