V-269964

Discussion

STP is implemented on bridges and switches to prevent Layer 2 loops when a broadcast domain spans multiple bridges and switches and when redundant links are provisioned to provide high availability in case of link failures. Convergence time can be significantly reduced using Rapid STP (802.1w) instead of STP (802.1d), resulting in improved availability. Rapid STP should be deployed by implementing either Rapid Per-VLAN-Spanning-Tree (Rapid-PVST) or Multiple Spanning-Tree Protocol (MSTP); the latter scales much better when there are many VLANs.

Check Content

In cases where VLANs do not span multiple switches, it is a best practice to not implement STP. Avoiding the use of STP will provide the most deterministic and highly available network topology. If STP is required, then review the switch configuration to verify that Rapid STP has been implemented. 

OS10# show running-configuration
...
...
spanning-tree mode rstp

Note: MSTP can be configured as an alternate mode. MSTP uses RSTP for rapid convergence and enables multiple VLANs to be grouped into and mapped to the same spanning-tree instance, thereby reducing the number of spanning-tree instances needed to support many VLANs.

OS10# show running-configuration
...
...
spanning-tree mode mst

If Rapid STP or MSTP have not been implemented where STP is required, this is a finding.