STIGhubSTIGhub
STIGsSearchCompareAbout

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • Compare Versions

Resources

  • About
  • VPAT
  • DISA STIG Library
STIGs updated 2 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Arista MLS DCS-7000 Series RTR Security Technical Implementation Guide

V-217493

CAT II (Medium)

The Arista Multilayer Switch must protect an enclave connected to an Alternate Gateway by using an inbound filter that only permits packets with destination addresses within the sites address space.

Rule ID

SV-217493r382735_rule

STIG

Arista MLS DCS-7000 Series RTR Security Technical Implementation Guide

Version

V1R4

CCIs

CCI-001414

Discussion

Enclaves with Alternate Gateway connections must take additional steps to ensure there is no compromise on the enclave network or NIPRNet. Without verifying the destination address of traffic coming from the site's Alternate Gateway, the perimeter router could be routing transit data from the Internet into the NIPRNet. This could also make the perimeter router vulnerable to a DoS attack as well as provide a backdoor into the NIPRNet. The DoD enclave must ensure the ingress filter applied to external interfaces on a perimeter router connecting to an Approved Gateway is secure through filters permitting packets with a destination address belonging to the DoD enclave's address block.

Check Content

Review the configuration of each router interface connecting to an Alternate Gateway via the "show running-config" command.

Verify each permit statement of the ingress filter only permits packets with destination addresses of the site's NIPRNet address space or a destination address belonging to the address block assigned by the Alternate Gateway network service provider.

If the ingress filter permits packets with addresses other than those specified, such as destination addresses of the site's NIPRNet address space or a destination address belonging to the address block assigned by the Alternate Gateway network service provider, this is a finding.

Fix Text

Configure the ingress filter of the perimeter router connected to an Alternate Gateway to only permit packets with destination addresses of the site's NIPRNet address space or a destination address belonging to the address block assigned by the Alternate Gateway network service provider. To configure an example of such a statement, enter:

ip access-list [name]
permit ip [source] [destination]
exit
interface [router interface]
ip access-group [name] in
exit