← Back to Forescout Network Access Control Security Technical Implementation Guide

V-233329

CAT II (Medium)

Forescout must configure TCP for the syslog protocol to allow for detection by the central event server if communications is lost. This is required for compliance with C2C Step 1.

Rule ID

SV-233329r811408_rule

STIG

Forescout Network Access Control Security Technical Implementation Guide

Version

V2R4

CCIs

CCI-000139

Discussion

It is critical for the appropriate personnel to be aware if a system is at risk of failing to process audit logs as required. Without this notification, the security personnel may be unaware of an impending failure of the audit capability and system operation may be adversely affected. Note that this configuration allows for the central log server to be configured with a critical alert to be sent to the System Security Officer (ISSO) and Systems Administrator (SA) (at a minimum) if it is unable to communicate the Forescout or stops receiving log updates. The alert requirement is in the Syslog STIG.

Check Content

If DoD is not at C2C Step 1 or higher, this is not a finding.

1. Go to Tools >> Options >> Syslog.
2. Verify the Server Protocol is set to TCP.
3. Verify "Use TLS" setting is set.
4. Verify the "Identity, Facility, and Severity" setting is configured.

If Forescout does not use TCP for the syslog protocol, this is a finding.

Fix Text

Configure Syslog server with TCP, as well as configure Syslog to alert if the communication between the Syslog server and the Forescout appliance loses connectivity.

1. Go to Tools >> Options >> Syslog.
2. Click Add/Edit.
3. Configure the Syslog:
- Syslog Server IP address
- Server Port
- Server Protocol set to TCP
- Check the Use TLS setting
- Configure the Identity, Facility, and Severity.
4. Click "OK".
5. Click "Apply".