STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 6 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Tri-Lab Operating System Stack (TOSS) 4 Security Technical Implementation Guide

V-253124

CAT II (Medium)

TOSS must not forward IPv4 source-routed packets by default.

Rule ID

SV-253124r991589_rule

STIG

Tri-Lab Operating System Stack (TOSS) 4 Security Technical Implementation Guide

Version

V2R5

CCIs

CCI-000366

Discussion

Source-routed packets allow the source of the packet to suggest that routers forward the packet along a different path than configured on the router, which can be used to bypass network security measures. This requirement applies only to the forwarding of source-routed traffic, such as when forwarding is enabled and the system is functioning as a router.

Check Content

Verify TOSS does not accept IPv4 source-routed packets by default.

Note: If IPv4 is disabled on the system, this requirement is Not Applicable.

Check the value of the accept source route variable with the following command:

$ sudo sysctl net.ipv4.conf.default.accept_source_route

net.ipv4.conf.default.accept_source_route = 0

If the returned line does not have a value of "0", a line is not returned, or the line is commented out, this is a finding.

Fix Text

Configure TOSS to not forward IPv4 source-routed packets by default with the following command:

$ sudo sysctl -w net.ipv4.conf.default.accept_source_route=0

If "0" is not the system's default value then add or update the following line in the appropriate file under "/etc/sysctl.d":

net.ipv4.conf.default.accept_source_route=0