STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 3 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Cisco IOS XR Router RTR Security Technical Implementation Guide

V-216748

CAT II (Medium)

The Cisco router must be configured to have Internet Control Message Protocol (ICMP) redirect messages disabled on all external interfaces.

Rule ID

SV-216748r856439_rule

STIG

Cisco IOS XR Router RTR Security Technical Implementation Guide

Version

V3R3

CCIs

CCI-002385

Discussion

The ICMP supports IP traffic by relaying information about paths, routes, and network conditions. Routers automatically send ICMP messages under a wide variety of conditions. Redirect ICMP messages are commonly used by attackers for network mapping and diagnosis.

Check Content

Review the router configuration to verify that ipv4 redirects command has not been configured on any external interface as shown in the example below.

interface GigabitEthernet0/0/0/1
 ipv4 address x.11.1.2 255.255.255.252
 ipv4 redirects

If ICMP Redirect messages are enabled on any external interfaces, this is a finding.

Fix Text

Disable ICMP redirects on all external interfaces as shown in the example below.

RP/0/0/CPU0:R3(config)#int g0/0/0/1
RP/0/0/CPU0:R3(config-if)#no ipv4 redirects