STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 6 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to SLES 12 Security Technical Implementation Guide

V-217295

CAT II (Medium)

The SUSE operating system must not send Internet Protocol version 4 (IPv4) Internet Control Message Protocol (ICMP) redirects.

Rule ID

SV-217295r991589_rule

STIG

SLES 12 Security Technical Implementation Guide

Version

V3R2

CCIs

V-77499

Discussion

ICMP redirect messages are used by routers to inform hosts that a more direct route exists for a particular destination. These messages contain information from the system's route table, possibly revealing portions of the network topology.

Check Content

Verify the SUSE operating system does not send IPv4 ICMP redirect messages.

Check the value of the "all send_redirects" variables with the following command:

# sysctl net.ipv4.conf.all.send_redirects
net.ipv4.conf.all.send_redirects =0

If the returned line does not have a value of "0” this is a finding.

Fix Text

Configure the SUSE operating system to not allow interfaces to perform IPv4 ICMP redirects. 

Set the system to the required kernel parameter by adding the following line to "/etc/sysctl.conf" (or modify the line to have the required value):

net.ipv4.conf.all.send_redirects=0

Run the following command to apply this value:

# sysctl --system