STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 2 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Ivanti EPMM Server Security Technical Implementation Guide

V-251420

CAT I (High)

The Ivanti EPMM server must use a FIPS-validated cryptographic module to generate cryptographic hashes.

Rule ID

SV-251420r1004747_rule

STIG

Ivanti EPMM Server Security Technical Implementation Guide

Version

V3R1

CCIs

CCI-002450

Discussion

FIPS 140-2 precludes the use of invalidated cryptography for the cryptographic protection of sensitive or valuable data within Federal systems. Unvalidated cryptography is viewed by NIST as providing no protection to the information or data. In effect, the data would be considered unprotected plaintext. If the agency specifies that the information or data be cryptographically protected, then FIPS 140-2 is applicable. In essence, if cryptography is required, it must be validated. Cryptographic modules that have been approved for classified use may be used in lieu of modules that have been validated against the FIPS 140-2 standard. The cryptographic module used must have at least one validated hash algorithm. This validated hash algorithm must be used to generate cryptographic hashes for all cryptographic security function within the product being evaluated. Satisfies: FCS_COP.1.1(2)

Check Content

On the MDM console, do the following:
1. SSH to MobileIron Core Server from any SSH client.
2. Enter the administrator credentials you set when you installed MobileIron Core.
3. Enter show fips.
4. Verify "FIPS 140 mode is enabled" is displayed.

If the MobileIron Server Core does not report that FIPS mode is enabled, this is a finding.

Fix Text

Configure the MDM server to use a FIPS 140-2 validated cryptographic module.

On the MDM console, do the following:
1. SSH to MobileIron Core Server from any SSH client.
2. Enter the administrator credentials you set when you installed MobileIron Core.
3. Enter enable.
4. When prompted, enter the enable secret you set when you installed MobileIron Core.
5. Enter configure terminal.
6. Enter the following command to enable FIPS: fips
7. Enter the following command to proceed with the necessary reload: do reload