← Back to Honeywell Android 9.x COPE Security Technical Implementation Guide

V-235081

CAT III (Low)

The Honeywell Mobility Edge Android Pie device must be configured to generate audit records for the following auditable events: detected integrity violations.

Rule ID

SV-235081r626531_rule

STIG

Honeywell Android 9.x COPE Security Technical Implementation Guide

Version

V1R2

CCIs

CCI-000169

Discussion

Audit logs enable monitoring of security-relevant events and subsequent forensics when breaches occur. They help identify attacks so that breaches can either be prevented or limited in their scope. They facilitate analysis to improve performance and security. The Requirement Statement lists key events the system must generate in an audit record. Application note: Requirement applies only to integrity violation detections that can be logged by the audit logging component. SFR ID: FMT_SMF_EXT.1.1 #37

Check Content

Review Honeywell Android device configuration settings to determine if the mobile device is configured to generate audit records for the following auditable events: detected integrity violations.

This validation procedure is performed only on the MDM Administration console. 

On the MDM console:
1. Go to Policy management.
2. Confirm Security Logging is enabled.

If the MDM console device policy is not set to enable security logging, this is a finding.

Fix Text

Configure the Honeywell Android device to generate audit records for the following auditable events: detected integrity violations.

On the MDM console:
1. Go to Policy management.
2. Enable Security Logging.