STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 1 hour ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to HPE 3PAR StoreServ 3.2.x Security Technical Implementation Guide

V-237823

CAT III (Low)

The storage system must, for networked systems, compare internal information system clocks at least every 24 hours with a server which is synchronized to one of the redundant United States Naval Observatory (USNO) time servers, or a time server designated for the appropriate DoD network (NIPRNet/SIPRNet), and/or the Global Positioning System (GPS).

Rule ID

SV-237823r647878_rule

STIG

HPE 3PAR StoreServ 3.2.x Security Technical Implementation Guide

Version

V2R1

CCIs

CCI-001891

Discussion

Inaccurate time stamps make it more difficult to correlate events and can lead to an inaccurate analysis. Determining the correct time a particular event occurred on a system is critical when conducting forensic analysis and investigating system events. Sources outside the configured acceptable allowance (drift) may be inaccurate. Synchronizing internal information system clocks provides uniformity of time stamps for information systems with multiple system clocks and systems connected over a network. Organizations should consider endpoints that may not have regular access to the authoritative time server (e.g., mobile, teleworking, and tactical endpoints).

Check Content

Verify NTP is operational by entering the following command:

cli% shownet 
< multiple lines of heading, and node network information>
NTP server : <ip address of ntp server>

If one of the lines of the output does not show the correct NTP server IP address, this is a finding.

Fix Text

Enable NTP on the system by entering the following command:

cli% setnet ntp <server_addr>