STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 4 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Cisco IOS XR Router NDM Security Technical Implementation Guide

V-216542

CAT I (High)

The Cisco router must be configured to implement cryptographic mechanisms to protect the confidentiality of remote maintenance sessions.

Rule ID

SV-216542r961557_rule

STIG

Cisco IOS XR Router NDM Security Technical Implementation Guide

Version

V3R6

CCIs

CCI-003123

Discussion

This requires the use of secure protocols instead of their unsecured counterparts, such as SSH instead of telnet, SCP instead of FTP, and HTTPS instead of HTTP. If unsecured protocols (lacking cryptographic mechanisms) are used for sessions, the contents of those sessions will be susceptible to eavesdropping, potentially putting sensitive data (including administrator passwords) at risk of compromise and potentially allowing hijacking of maintenance sessions.

Check Content

Review the router configuration to verify that SSH version 2 is configured as shown in the example below.

ssh server v2

Note: IOS XR supports SSHv1 and SSHv2. The AES encryption algorithm is supported on the SSHv2 server and client, but not on the SSHv1 server and client. Any requests for an AES cipher sent by an SSHv2 client to an SSHv1 server are ignored, with the server using 3DES instead. The cipher preference for the SSH server follows the order AES128, AES192, AES256, and, finally, 3DES. The server rejects any requests by the client for an unsupported cipher, and the SSH session does not proceed.

If the router is configured to implement SSH version 1, this is a finding.

Fix Text

Configure the router to use SSH version 2 as shown in the example below.

RP/0/0/CPU0:R3(config)#ssh server v2