STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 6 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to Tri-Lab Operating System Stack (TOSS) 5 Security Technical Implementation Guide

V-282605

CAT II (Medium)

TOSS 5 must protect against or limit the effects of denial-of-service (DoS) attacks by ensuring rate-limiting measures on impacted network interfaces are implemented.

Rule ID

SV-282605r1200795_rule

STIG

Tri-Lab Operating System Stack (TOSS) 5 Security Technical Implementation Guide

Version

V1R1

CCIs

CCI-002385

Discussion

DoS is a condition when a resource is not available for legitimate users. When this occurs, the organization either cannot accomplish its mission or must operate at degraded capacity. This requirement addresses the configuration of TOSS 5 to mitigate the impact of DoS attacks that have occurred or are ongoing on system availability. For each system, known and potential DoS attacks must be identified and solutions for each type implemented. A variety of technologies exists to limit or, in some cases, eliminate the effects of DoS attacks (e.g., limiting processes or establishing memory partitions). Employing increased capacity and bandwidth, combined with service redundancy, may reduce the susceptibility to some DoS attacks.

Check Content

Verify "nftables" is configured to allow rate limits on any connection to the system using the following command:

$ sudo grep -i firewallbackend /etc/firewalld/firewalld.conf

# FirewallBackend
FirewallBackend=nftables

If the "nftables" is not set as the "FirewallBackend" default, this is a finding.

Fix Text

Configure "nftables" to be the default "firewallbackend" for "firewalld" by adding or editing the following line in "etc/firewalld/firewalld.conf":

FirewallBackend=nftables

Establish rate-limiting rules based on organization-defined types of DoS attacks on impacted network interfaces.