← Back to Cisco ACI Router Security Technical Implementation Guide

V-272074

CAT III (Low)

The multicast rendezvous point (RP) Cisco ACI must be configured to filter Protocol Independent Multicast (PIM) Join messages received from the designated router (DR) for any undesirable multicast groups.

Rule ID

SV-272074r1168396_rule

STIG

Cisco ACI Router Security Technical Implementation Guide

Version

V1R2

CCIs

CCI-001414

Discussion

Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast packets, over-using the available bandwidth and thereby creating a denial-of-service (DoS) condition. Hence, it is imperative that join messages are only accepted for authorized multicast groups. In a Cisco ACI fabric, the border leaf switches are responsible for handling external multicast traffic and are where access control lists (ACLs) to filter PIM Join messages would be applied.

Check Content

View the configuration to verify PIM compliance.

Configure the relevant multicast enabled interfaces by configuring a route map on the PIM settings for the VRF on the GUI. Navigate to Tenants >> {{your_Tenants}} >> Networking >> VRFs >> {{Your_VRF}} >> multicast >> Configuration >> PIM settings >> Reserved Route MAP.

If the Cisco ACI is not configured to filter join messages received from the DR for any undesirable multicast groups, this is a finding.

Fix Text

Configure ACLs on the border leaf switches that act as the PIM DRs, specifically targeting the multicast group addresses to be blocked. This essentially prevents unwanted multicast traffic from entering the fabric by filtering the Join messages at the entry point.

Configure the relevant multicast enabled interfaces by configuring a route map on the PIM settings for the VRF on the GUI. Navigate to Tenants >> {{your_Tenants}} >> Networking >> VRFs >> {{Your_VRF}} >> multicast >> Configuration >> PIM settings >> Reserved Route MAP.