← Back to Cisco IOS XE Router RTR Security Technical Implementation Guide

V-216676

CAT II (Medium)

The Cisco perimeter router must be configured to have Proxy ARP disabled on all external interfaces.

Rule ID

SV-216676r855823_rule

STIG

Cisco IOS XE Router RTR Security Technical Implementation Guide

Version

V3R5

CCIs

CCI-002403

Discussion

When Proxy ARP is enabled on a router, it allows that router to extend the network (at Layer 2) across multiple interfaces (LAN segments). Because proxy ARP allows hosts from different LAN segments to look like they are on the same segment, proxy ARP is only safe when used between trusted LAN segments. Attackers can leverage the trusting nature of proxy ARP by spoofing a trusted host and then intercepting packets. Proxy ARP should always be disabled on router interfaces that do not require it, unless the router is being used as a LAN bridge.

Check Content

This requirement is not applicable for the DODIN Backbone.

Review the router configuration to determine if IP Proxy ARP is disabled on all external interfaces as shown in the example below:

interface GigabitEthernet0/1
 description link to DISN
 ip address x.1.12.2 255.255.255.252
 no ip proxy-arp

Note: By default Proxy ARP is enabled on all interfaces; hence, if enabled, it will not be shown in the configuration. 

If IP Proxy ARP is enabled on any external interface, this is a finding.

Fix Text

This requirement is not applicable for the DODIN Backbone.

Disable Proxy ARP on all external interfaces as shown in the example below:

R2(config)#int g0/1     
R2(config-if)#no ip proxy-arp