STIGhubSTIGhub
STIGsRMF ControlsCompare

STIGhub

A free tool to search and browse the entire DISA STIG library. Saves up to 75% in security compliance research time.

Navigation

  • Browse STIGs
  • Search
  • RMF Controls
  • Compare Versions

Resources

  • About
  • Release Notes
  • VPAT
  • DISA STIG Library
STIGs updated 6 hours ago
Powered by Pylon
© 2026 Beacon Cloud Solutions, Inc. All rights reserved.
← Back to SLES 12 Security Technical Implementation Guide

V-217298

CAT II (Medium)

The SUSE operating system wireless network adapters must be disabled unless approved and documented.

Rule ID

SV-217298r991568_rule

STIG

SLES 12 Security Technical Implementation Guide

Version

V3R2

CCIs

V-77505

Discussion

Without protection of communications with wireless peripherals, confidentiality and integrity may be compromised because unprotected communications can be intercepted and either read, altered, or used to compromise the SUSE operating system. This requirement applies to wireless peripheral technologies (e.g., wireless mice, keyboards, displays, etc.) used with A SUSE operating system. Wireless peripherals (e.g., Wi-Fi/Bluetooth/IR Keyboards, Mice, and Pointing Devices and Near Field Communications [NFC]) present a unique challenge by creating an open, unsecured port on a computer. Wireless peripherals must meet DoD requirements for wireless data transmission and be approved for use by the AO. Even though some wireless peripherals, such as mice and pointing devices, do not ordinarily carry information that need to be protected, modification of communications with these wireless peripherals may be used to compromise the SUSE operating system. Communication paths outside the physical protection of a controlled boundary are exposed to the possibility of interception and modification. Protecting the confidentiality and integrity of communications with wireless peripherals can be accomplished by physical means (e.g., employing physical barriers to wireless radio frequencies) or by logical means (e.g., employing cryptographic techniques). If physical means of protection are employed, then logical means (cryptography) do not have to be employed, and vice versa. If the wireless peripheral is only passing telemetry data, encryption of the data may not be required. Satisfies: SRG-OS-000299-GPOS-00117, SRG-OS-000300-GPOS-00118, SRG-OS-000481-GPOS-000481

Check Content

Verify that the SUSE operating system has no wireless network adapters enabled.

Check that there are no wireless interfaces configured on the system with the following command:

# wicked show all

lo up
link: #1, state up
type: loopback
config: compat:suse:/etc/sysconfig/network/ifcfg-lo
leases: ipv4 static granted
leases: ipv6 static granted
addr: ipv4 127.0.0.1/8 [static]
addr: ipv6 ::1/128 [static]

eth0 up
link: #2, state up, mtu 1500
type: ethernet, hwaddr 06:00:00:00:00:01
config: compat:suse:/etc/sysconfig/network/ifcfg-eth0
leases: ipv4 dhcp granted
leases: ipv6 dhcp granted, ipv6 auto granted
addr: ipv4 10.0.0.100/16 [dhcp]
route: ipv4 default via 10.0.0.1 proto dhcp

wlan0 up
link: #3, state up, mtu 1500
type: wireless, hwaddr 06:00:00:00:00:02
config: wicked:xml:/etc/wicked/ifconfig/wlan0.xml
leases: ipv4 dhcp granted
addr: ipv4 10.0.0.101/16 [dhcp]
route: ipv4 default via 10.0.0.1 proto dhcp

If a wireless interface is configured it must be documented and approved by the local Authorizing Official.

If a wireless interface is configured and has not been documented and approved, this is a finding.

Fix Text

Configure the SUSE operating system to disable all wireless network interfaces with the following command:

For each interface of type wireless, bring the interface into "down" state:

# wicked ifdown wlan0

For each interface of type wireless with a configuration of type "compat:suse:", remove the associated file:

# rm /etc/sysconfig/network/ifcfg-wlan0

For each interface of type wireless, for each configuration of type "wicked:xml:", remove the associated file or remove the interface configuration from the file.

# rm /etc/wicked/ifconfig/wlan0.xml