← Back to Cisco ACI Router Security Technical Implementation Guide

V-272069

CAT II (Medium)

The multicast Cisco ACI must be configured to bind a Protocol Independent Multicast (PIM) neighbor filter to interfaces that have PIM enabled.

Rule ID

SV-272069r1168390_rule

STIG

Cisco ACI Router Security Technical Implementation Guide

Version

V1R2

CCIs

CCI-001414

Discussion

PIM is a routing protocol used to build multicast distribution trees for forwarding multicast traffic across the network infrastructure. PIM traffic must be limited to only known PIM neighbors by configuring and binding a PIM neighbor filter to those interfaces that have PIM enabled. If a PIM neighbor filter is not applied to those interfaces that have PIM enabled, unauthorized routers can join the PIM domain, discover and use the rendezvous points, and also advertise their rendezvous points into the domain. This can result in a denial of service (DoS) by traffic flooding or result in the unauthorized transfer of data.

Check Content

1. Review the network's multicast topology diagram.
2. Review the switch configuration to verify only the PIM interfaces as shown in the multicast topology diagram are enabled for PIM. Navigate to Tenants >> {{your_Tenants}} >> Networking >> VRFs >> {{Your_VRF}} >> multicast >> Configuration >> PIM settings >> Reserved Route MAP.

If a multicast interface is required to support PIM and it is not enabled, this is a finding.

Fix Text

Configure the relevant multicast enabled interfaces by configuring a route map on the PIM settings for the VRF on the GUI. Navigate to Tenants >> {{your_Tenants}} >> Networking >> VRFs >> {{Your_VRF}} >> multicast >> Configuration >> PIM settings >> Reserved Route MAP.